Glock 22 30 Round - The loaders failed to feed the Glock 22 when inserted into the CAA MCK chassis. I bought 6 and they were all 1 shot wonders when loaded with 5+ rounds.
They went well with the gun when it was out of the chassis. The chassis creates enough extra drag to mess up the feed.
Glock 22 30 Round
I bought 4 to use in my sub 2000. I started with 25 rounds in each magazine and had 1 malfunction out of every 100 rounds. I loaded 30 rounds and 2 magazines with no problems. I haven't used it on my Glock 22 or 23 but will post a review after I test it.
Kci .40 S&w 31 Round Polymer Magazine For Glock 22, 23, 27, 35
I bought 4 of these to go with a .40 S&W AR build based on the lower TN Arms Company Tac-9. They work perfectly with little movement when they fit in the magazine. I was concerned about spring waring when Glock springs were fully loaded and purchased. The original ETS springs performed better than the Glock replacements.
I love this magazine, it fits my Glock 23 perfectly and feeds my ammo very well. Quality is A-1. I would like to buy more once they are back in stock
This magazine will take S&W .40 ammo, but will not fit the S&W SD40 VE. The magazine is too big. The Strike Industries Extended Magazine Plate for the GLOCK G17 9MM/G22 .40 Cal was designed to provide smooth magazine reloading through a slow drag/no-stick design while maintaining maximum magazine capacity with any OEM GLOCK magazine. The extended magazine plate provides an additional 6 rounds to any G17 GLOCK magazine plus an additional 5 to any G22 .40 cal magazine. Includes our special steel locking plate. Compared to other magazine extension plates on the market, our steel locking plate has a hook design that adds extra locking security to increase the durability of your magazine and extended magazine plate when fully loaded with rounds. Our extended magazine plate provides better grip and overall control while increasing overall reloading efficiency. Give your GLOCK the extra rounds it deserves with the Strike Industries Extended Magazine Plate for the GLOCK G17 9mm/G22 .40 Cal.
10+ round ETS magazines. Please note that ETS changes its design and we cannot control or know if SI EMP is no longer supported.
Glock 22 Gen4 40 S&w Police Trade In Pistols With Night Sights (very Good Condition)
Disclaimer: Due to variation in 40 CAL truncated bullet design and overall length, some feeding issues may be experienced. Long common bullet heads have increased defects. If you are having these issues, please contact Strike Industries for assistance.
WARNING: Do not over tighten the set screws when installing the steel lock plate. The steel locking plate may look "loose", but when the set screws are flush with the back of the EMP body, you don't need to learn much. Over tightening after this point may damage your product. Watch the video instructions to install the correct item. If you are unsure, please contact our customer support team or check with your local gunsmith.
Best glock 22 holster, glock 100 round drum, glock 30 slim, glock 22 holster, 10 22 30 round clips, glock 30 round magazine pouch, glock 22 molle holster, glock 22 caliber, disassemble glock 22, 30 round 22, 22 30 round clip, glock 22 conceal holster